Home Theater Sound Setup (Rcs-404H/Rcs-505H); Standard Surround Setup - Pioneer RCS-404H Operating Instructions Manual

Speaker Setup Guide
3 Secure each of the front and surround speakers
using the metal catch provided.
Screw two picture hooks or similar into the wall behind
the speaker. Pass a chain or cord around the hooks and
through the metal catch so that the speaker is stabilized
(make sure to test that it supports the weight of the
speaker).
After installing, make sure the speaker is securely fixed.
Caution
• The metal catch is not a mounting fixture, and the
speaker should not be hung directly from the wall
using this catch. Always use a chain or cord when
stabilizing the speaker.
• Pioneer disclaims all responsibility for any losses or
damage resulting from improper assembly,
installation, insufficient strength of the installation
materials, misuse, or natural disasters.
4 Connect the speaker system.
Refer to Connecting up to connect the speakers properly.
After connecting everything, place the speakers as
shown in the diagram above for optimal surround sound.
After placing the speakers, run the Auto MCACC setup
(page 23) to complete your surround sound setup.
6
En
Home theater sound setup
(RCS-404H/RCS-505H)
Depending on the size and characteristics of your room,
you can place your speakers in one of two ways using this
system.

Standard surround setup

Chain or cord
This is a standard multichannel surround sound speaker
setup for optimal 5.1 channel home theater sound.
Metal catch
1
each of the front, surround and center speakers. The
four large non-skid pads are for the receiver
subwoofer (as shown).
Use the adhesive side of the pads to attach them to the
base (flat surface) of each speaker.
Front
left
Center
Surround
left
Listening position
Attach the smaller non-skid pads to the base of
Non-skid pads
(small) x 20
Non-skid pads
(large) x 4
Front
right
Receiver subwoofer
Surround
right
Front and surround speakers
Center speaker
Receiver
subwoofer