Using This Unit With A Pioneer Plasma Display; Sr+ Setup For Pioneer Plasma Displays - Pioneer RCS-404H Operating Instructions Manual

Other connections
For an external FM antenna, Use a PAL connector to hook
up an external FM antenna.
Using this unit with a Pioneer plasma
display
If you have a Pioneer plasma display
2
SR+ cable to connect it to this unit and take advantage
of various convenient features, such as controlling this
unit via the plasma display's remote sensor, automatic
video input switching of the plasma display, display unit
messages appearing on the plasma display screen, and
automatic volume muting on the plasma display.
Media receiver
CONTROL
OUT
CONTROL IN
MCACC
SETUP MIC
CONTROL SPEAKERS
DVD/DVR 1
SYSTEM CONNECTOR
OUT SUB WOOFER R SURROUND L
(COAXIAL)
USE ONLY WITH
DISPLAY UNIT
CENTER R FRONT L
AC IN
Important
• With an SR+ cable connected, the remote must now
be pointed towards your plasma display rather than
the display unit of the receiver subwoofer in order to
control the receiver subwoofer.
Note
1 This system is compatible with all Pioneer plasma displays from 2003 onward.
2 The 3-ringed SR+ cable from Pioneer is commercially available under the part number ADE7095. Contact the Pioneer Customer Support division for
more information on obtaining an SR+ cable.
3 You won't be able to use the remote sensor of this unit with the CONTROL IN jack of this unit connected to the CONTROL OUT jack of your plasma
display. You can use the remote sensor of the plasma display (even in standby) as long as the power isn't switched off.
PAL connector
1
, you can use an
Pioneer plasma display
ANTENNA
FM AM
UNBAL 75Ω LOOP ANTENNA
AUDIO INPUT
DIGITAL
DVD/DVR 2 DIGITAL ANALOG
(OPTICAL) (OPTICAL)
L
R
• Use a 3-ringed miniplug SR+ cable to connect the
CONTROL IN jack of this unit (through a media
receiver, if applicable) to the CONTROL OUT jack of
3
your plasma display.
Before you can use the extra SR+ features, you need to
make a few settings in the unit—see SR+ Setup for
Pioneer plasma displays below.

SR+ Setup for Pioneer plasma displays

Make the following settings if you have connected a
Pioneer plasma display to this unit using an SR+ cable.
SET UP
1 2
ENTER
4 5
MCACC
7 8
SURROUND ADVANCED
0
SLEEP
+
INPUT CHANNEL
–
TV CONTROL
MAIN SUB
1 Press SR+.
2 Use the buttons to choose SETUP, then
press ENTER.
3 Use the buttons to choose the setting you
want to adjust.
The current setting is shown for each option as you cycle
through the display. See below for a full list and
description of each.
4 Use the buttons to adjust the setting.
5 Repeat steps 3 and 4 to make other settings.
6 When you're done, press ENTER to leave the SR+
setup menu.
TIMER REC REC MODE
+
SR ONE TOUCH COPY
3
MENU
6
TEST TONE VIDEO IN
9
SOUND TV/DVD
CLEAR
JUKE BOX
+
VOLUME DISPLAY
–
RDS DISP
AXD7442
06
35
En