Using The Remote Control; Putting The Batteries In The Remote Control - Pioneer RCS-404H Operating Instructions Manual

Remote control
SOUND (page 27)
Press to access the sound menu, from which you can
adjust bass and treble, etc.
CLEAR
Press to clear an entry and start again.
23 MENU (page 87)
Press to display the disc menu if a DVD-Video, finalized
DVD-R/-RW or finalized DVD+R/+RW disc is loaded.
When in the GUIDE Plus+™ system, use to jump directly
to the Menu bar.
24 VIDEO IN (page 82)
Press to change the DVD recorder input for recording
and playback.
25 TV/DVD
Press to switch between 'TV mode', in which you get the
picture and sound from the TV's tuner, and 'DVD mode',
in which you get picture and sound from the system's
tuner (or an external input).
26 JUKEBOX (page 113)
Press to display the Jukebox screen of the DVD recorder,
from where you can copy music to the HDD for playback.
27 TV CONTROL (page 136)
After setting up, use these controls to control your TV.
28 DISPLAY (page 95)
Displays/changes the on-screen information
displays.
RDS DISP
Changes RDS displays (page 30).
29 MAIN / SUB
Change from MAIN to SUB to access the green
functions/commands on the remote.

Using the remote control

Please keep in mind the following when using the remote
control:
• Make sure that there are no obstacles between the
remote and the remote sensor on the unit.
• Remote operation may become unreliable if strong
sunlight or fluorescent light is shining on the unit's
remote sensor.
• Remote controllers for different devices can interfere
with each other. Avoid using remotes for other
equipment located close to this unit.
• Replace the batteries when you notice a fall off in the
operating range of the remote.
• When the batteries run down or you change the
batteries, the remote control mode is reset to
Recorder 1. See Remote Control Mode on page 134.
• Use within the operating range in front of the remote
control sensor on the display unit, as shown.
Putting the batteries in the remote
control
1 Open the battery compartment cover on the
back of the remote control.
2 Insert two AA/R6 batteries into the battery
compartment following the indications ( , ) inside
the compartment.
3 Close the cover.
Caution
Incorrect use of batteries can result in hazards such
as leakage and bursting. Please observe the
following:
• Don't mix new and old batteries together.
• Don't use different kinds of battery together—
although they may look similar, different batteries
may have different voltages.
• Make sure that the plus and minus ends of each
battery match the indications in the battery
compartment.
• Remove batteries from equipment that isn't going to
be used for a month or more.
• When disposing of used batteries, please comply
with governmental regulations or environmental
public instruction's rules that apply in your country or
area.
WARNING
• Do not use or store batteries in direct sunlight or
other excessively hot place, such as inside a car or
near a heater. This can cause batteries to leak,
overheat, explode or catch fire. It can also reduce the
life or performance of batteries.
30
30
7m
17
En