Appendix; Appendix 1 Operations Of When The Mc/Mcr Instructions Are Used To Control En - Mitsubishi Electric MELSEC iQ-R Series Programming Manual

APPENDIX

Appendix 1
The following table lists operations of instructions, devices, and labels used in a function block when "Use MC/MCR in EN
Control" is enabled in the inherent property setting of the function block.
Instruction/device/label used in a function
block
Instructions executed at the rising edge or falling
edge (PLS, instructions for conversion to pulses
*1
(P))
Timer (low-speed/high-speed), long timer
Retentive timer (low-speed/high-speed), long
retentive timer, counter, long counter
Devices specified as the device part of the OUT
instruction
*1 Instructions specified in the coil side apply.
APPX
152

Appendix 1 Operations of when the MC/MCR instructions are used to control EN

Operations of when the MC/MCR
instructions are used to control EN
Operation of Instruction/device/label used in a function block
"Yes" for "Use MC/MCR in EN Control"
The next time EN is turned on, the instruction is
executed if the condition contact is TRUE.
The count value becomes 0 and the both coil
and contact turn off.
The coil turns off, but the current count value
and the current state of the contact remain
unchanged.
The devices are forcibly turned off.
"No" for "Use MC/MCR in EN Control"
The next time EN is turned on, the instruction may
not be executed even though the condition contact is
TRUE.
The state of devices remains unchanged.
The state of devices remains unchanged.
The state of devices remains unchanged.