Using Cycle Programs - Brother BAS-311H Instruction Manual

6. USING THE OPERATION PANEL (ADVANCED OPERATIONS)

6-3. Using cycle programs

Sewing patterns that have been recorded in user programs can be recorded in up to 30 cycle programs (C01 to C30).
One cycle program can contain up to a maximum of 50 steps (St1 to St50).
When sewing the sewing patterns in a certain order, it can be useful to record them in a cycle program beforehand.
* If memory switch No. 400 is set to OFF, cycle program setting and selection cannot be carried out.
<Recording method>
Switch to cycle program recording mode.
1
3102B
2 Select a cycle program number.
3103B
Select the program number to be recorded in step 1.
3
4 Apply the program setting.
43
TEST indicator flashes
TEST indicator flashes
TEST indicator flashes
BAS-311H
While pressing the TEST key, press the
・ The cycle program number (C01 to C30) will be
displayed in the PROGRAM No. display, the step
number (St1 to St50) will be displayed in the menu
display, and the program number will be displayed in
the TENSION display.
・ If no program has been recorded for a step, '---' will
be displayed for that step.
Press the or key to select the cycle program
number that you would like to use.
'St 1' will be displayed.
•
Press the or key (2) to display the program
number to be recorded in the TENSION display (3).
・ If the value is changed, the display will change to
flashing.
・ To cancel the recording, keep the RESET key
pressed for more than 2 seconds so that '---' is
displayed.
Press the ENTER key.
・ The display will change from flashing to illuminated,
and this means that the setting has been applied.
・ If you press the /
the TEST key without pressing the ENTER key, you
can cancel the parameter changes.
key (1).
2436B 2382B
3104B 2382B 2383B
keys (4), the / keys (5) or
2414B