Brother BAS-311H Instruction Manual page 48

5. USING THE OPERATION PANEL (BASIC OPERATIONS)
3
<Changing modes>
4
Ending setting mode
THREAD/CLAMP indicator switches off
Intermittent presser foot operation
During standby
When lowered
While sewing
5033Q
39
Press the
The sewing machine will switch to intermittent presser foot height
setting mode.
• " 4" will appear in the PROGRAM No. display, and the work clamp
will rise to the setting value that appears in the menu display.
(Intermittent presser foot height setting: 0.0 − 10.0)
Press the
• The intermittent presser foot will rise or drop to the height of the
new value that has been set.
• If you press the RESET key while the height display is flashing,
the setting value will return to the value before the change was
made.
• Press the ENTER key to accept the setting.
NOTE:
Motor-driven work clamp specifications
" 1" Threading mode
↑ ↓
" 2" Work clamp height setting mode
↑ ↓
" 3" Intermediate work clamp height setting mode (*)
↑ ↓
" 4" Intermittent presser foot height setting mode
Pneumatic work clamp specifications
" 1" Threading mode
↑ ↓
" 4" Intermittent presser foot height setting mode
Press the THREAD/CLAMP key.
• The setting values will be memorized.
• The work clamp will return to where it was before setting mode
was started.
BAS-311H
key.
or key to set the intermittent presser foot height.
After making the setting, be sure to turn the pulley once by hand
and check that the intermittent presser foot does not touch the
needle bar.
* When the setting value for memory switch No. 003 is "2"
1
Intermittent presser foot lift amount
2
Intermittent presser foot height
The settings can be made by the above
operations.
However, set the intermittent presser foot
height to a higher setting than the intermittent
stroke.
* If it is set smaller, the intermittent presser
foot will come into contact with the needle
plate.
3
Intermittent stroke
Refer to "10-14. Changing the intermittent
stroke" when making the adjustment.
3092B
3093B