Radio Communication - Ecom J2KN pro Operation Manual

6. Radio Communication

The J2KN Pro base unit communi-
cates wirelessly to the remote display
unit via radio transmisision. To unlock
the remote control unit, press on the tab
to unlock and release from the cradle on
the base unit.
The information exchange between
the remote control and base unit is
performed via radio transmission (915
MHz) with a coverage of approximately
100ft by free sight. The quality of the
radio transmission is documented by a
bar indication in the Main Menu.
If the J2KN base unit is switched off
and the remote control unit is on, the
display will show a message telling the
user to place the remote control unit
into the docking station (see below).
-- ECOM-J2KN --
Place J2KN in
basic mod.!
Quit with:
Troubleshooting Communication Issues
If there is interruption of the radio communication, an error
message is displayed (see below right). If this occurs frequently,
it may be necessary to re-sync the remote to the base unit:
1. Place remote unit into cradle
2. Go to Adjustments-> Internal->
RF Connect-> Standard-> OK
3. The base and remote are now synced
4. Go to Adjustments-> Internal->
RF Connect-> Remote -> OK
5. The remote can now be used as normal
Unlock
Gas analysis
Averaging
Draft/Pressure
Soot Test
Automatic meas.
Adjustments
Control
Diagnostics
Bar indication
radio quality
-- ECOM-J2KN --
Radio connection
interrupted!
Use cable or
switch on basic
module!
Quit with:
Page 12