Oki B820n User Manual page 223

Start a print job.
•
Log into the printer.
①
• It is possible to print with any value put into Name and Pass-
Note!
word. However, if User is "root", then the Password is required.
The default value is the last 6 alphanumerical digits of the MAC address.
#ftp 192.168.0.2
Connected to 192.168.0.2
220 EthernetBoard OkiLAN 9300e Ver 00.06 FTP Server.
User (192.168.0.2:none) :root
331 Password required.
Password
230 user Logged in.
Remote system type is FTP.
ftp>
Move to transfer destination directory.
②
• Files cannot be transfered the root directory.
Note!
ftp>cd /lp
250 Command OK.
ftp>pwd
257"/lp" is current directory.
ftp>
Set the transfer mode.
③
• There are two types of transfer mode, "BINARY Mode", which
Note!
outputs file details as they are, and "ASCII Mode", which
changes LF codes into CR+LF codes. If transferring files cre-
ated with the printer driver, use "BINARY Mode"
ftp> type binary
200 Type set to I.
ftp> type
Using binary mode to transfer files.
ftp>
Start a print job.
④
E.g. 1) If transferring "test.prn" print data
ftp> put test.prn
E.g. 2) If setting the print data with the absolute path "/users/
test/test.prn", and then transferring.
ftp> put /users/test/test.prn
Log out.
⑤
ftp> quit
• You can use the quote command's "stat" to check three states
Memo
- the client IP address, the login user name and the transfer
mode. Also, you can check the status of the printer by setting
a logical directory (lp, sjis, euc) after stat.
ftp> quote stat
211 - FTP server status:
Connected to: 192,168,0,3,5,112
User logged in: root
Transfer type: BINARY
Data connection: Closed.
211 End of status.
ftp>
ftp> quote stat /lp
211 - FTP directory status:
Ready
211 End of status.
ftp>
223