1-Port Oc-192/Stm-64 Pos/Rpr Xfp Spa Interface Specifications - Cisco XR 12000 Series Hardware Installation Manual

1-Port OC-192 STM-64 POS RPR XFP SPA Overview
Table 2-31
LED Label
ACTIVE
STATUS

1-Port OC-192/STM-64 POS/RPR XFP SPA Interface Specifications

The framer processes incoming and outgoing SONET or SDH frames. The framer operates at
OC-192/STM-64 line rates (9.95 Gbps).
Packet data is transported with a user-configured encapsulation (such as Point-to-Point Protocol [PPP])
and is mapped into the STS-192/STM-64 frame.
The 1-Port OC-192/STM-64 POS/RPR XFP SPA interface is compliant with the following RFCs:
•
•
For information on SNMP MIB support, see "Implementing SNMP on Cisco IOS XR Software" in
Cisco IOS XR System Management Configuration Guide.
1-Port OC-192/STM-64 POS/RPR XFP SPA Optical Transceiver Modules,
Connectors, and Cables
The 1-Port OC-192/STM-64 POS/RPR XFP SPA uses a single-mode, 9.95 Gbps, OC-192 optical fiber
(SONET STS-192 or SDH STM-64) optical transceiver module for SONET and SDH connection to the
network.
The 1-Port OC-192/STM-64 POS/RPR XFP SPA supports the following types of optical transceiver
module:
•
•
•
Cisco Systems qualifies the optics that are approved for use with its SPAs. As of Cisco IOS XR Software
Release 3.4.0, the above-listed XFPs are the only optical transceiver modules qualified for use.
Use a single-mode optical fiber that has a modal-field diameter of 8.7 ±0.5 microns (nominal diameter
is approximately 10/125 microns) to connect your router to a network.
Cisco XR 12000 Series Router SIP and SPA Hardware Installation Guide
2-42
1-Port OC-192/STM-64 POS/RPR XFP SPA LEDs (continued)
Color State
Off Off
Green On
Amber On
Off Off
Green On
Amber On
RFC 1662, PPP in HDLC-like Framing
RFC 2615, PPP over SONET/SDH
Single-mode short-reach (SR) XFP module—XFP-10GLR-OC192SR
Single-mode intermediate-reach (IR) XFP module—XFP-10GER-OC192IR
Single-mode very-long reach XFP module—XFP-10GZR-OC192LR
Chapter 2 Overview: Cisco XR 12000 Series Router Shared Port Adapters
Meaning
Port is not enabled by software.
Port is enabled by software, and loopback is off.
Port is enabled by software, and loopback is on.
SPA power off.
SPA is ready and operational.
SPA power is on and good, and the SPA is being configured.
OL-17438-04