8-Port Fastethernet Spa Leds; 8-Port Fastethernet Spa Cables, Connectors, And Pinouts - Cisco XR 12000 Series Hardware Installation Manual

Chapter 2 Overview: Cisco XR 12000 Series Router Shared Port Adapters

8-Port FastEthernet SPA LEDs

The 8-Port FastEthernet SPA has two types of LEDs: an A/L LED for each individual port and a STATUS
LED for the SPA, as shown in
Figure 2-5
1
Table 2-9
Table 2-9
LED Label
Port Number
A/L (0, 1, 2, 3, 4,
5, 6 or 7)
STATUS
1. In this case, port number refers to the numbered LEDs on the 8-Port FastEthernet SPA (0, 1, 2, 3, 4, 5, 6 or 7). Each LED

8-Port FastEthernet SPA Cables, Connectors, and Pinouts

The interface connectors on the 8-Port FastEthernet SPA are eight individual RJ-45 receptacles. You can
use all eight interface connectors simultaneously. Each connection supports IEEE 802.3 and Ethernet
10/100BASE-T interfaces compliant with appropriate standards. Cisco Systems does not supply
Category 5 unshielded twisted-pair (UTP) RJ-45 cables; these cables are available commercially.
Figure 2-6
OL-17438-04
8-Port FastEthernet SPA Faceplate
1
A/L A/L
A/L (Active/Link) LED
describes the 8-Port FastEthernet SPA LEDs.
8-Port FastEthernet SPA LEDs
Color
Off
Green
1
Amber
Off
Green
Amber
number on the 8-Port FastEthernet SPA references a port on the SPA.
shows the RJ-45 connector.
Figure 2-5.
A/L A/L
2 STATUS LED
State Meaning
Off Port is not enabled.
On Port is enabled and the link is up.
On Port is enabled and the link is down.
Off SPA power is off.
On SPA is ready and operational.
On SPA power is on and good, and the SPA is being
configured.
Cisco XR 12000 Series Router SIP and SPA Hardware Installation Guide
8 Port FastEthernet SPA Overview
A/L A/L A/L A/L
2
2-11