1-Port Oc-192C/Stm-64 Pos/Rpr Xfp Spa Interface Specifications - Cisco 7600 series Hardware Installation Manual

Chapter 3 Overview: Cisco 7600 Series Router Shared Port Adapters
Table 3-17
Table 3-17
LED Label
WRAP
PASSTHRU
MATESYNC
CARRIER
ACTIVE
STATUS

1-Port OC-192c/STM-64 POS/RPR XFP SPA Interface Specifications

The framer processes incoming and outgoing SONET or SDH frames. The framer operates at
OC-192c/STM-64 line rates (9.95 Gbps).
Packet data is transported with a user-configured encapsulation (such as Point-to-Point Protocol [PPP])
and is mapped into the STS-192c/STM-64 frame.
The 1-Port OC-192c/STM-64 POS/RPR XFP SPA interface is compliant with the following RFCs:
•
•
For information on SNMP MIB support, see "Implementing SNMP on Cisco IOS XR Software" in
Cisco IOS XR System Management Configuration Guide.
OL-5052-08
describes the 1-Port OC-192c/STM-64 POS/RPR XFP SPA LEDs.
1-Port OC-192c/STM-64 POS/RPR XFP SPA LEDs
Color State
Off Off
Green On
Amber On
Off Off
Amber On
Off Off
Green On
Off Off
Green On
Amber On
Blinking SRP mode mismatch alarm is indicated.
Off Off
Green On
Amber On
Off Off
Green On
Amber On
RFC 1662, PPP in HDLC-like Framing
RFC 2615, PPP over SONET/SDH
1-Port OC-192c/STM-64 POS/RPR XFP SPA Overview
Meaning
Port is not in wrap mode.
Port is in wrap mode somewhere on the ring.
Port is in wrap mode locally.
Port is not in pass-thru mode.
Port is in pass-thru mode.
Mate port is not synchronized.
Mate port is synchronized.
Port is not enabled by software.
Port is enabled by software, and there is a valid SONET signal
without alarms.
Port is enabled by software, and there is at least one alarm (LOS,
LOF, RDI, and so on).
Port is not enabled by software.
Port is enabled by software, and loopback is off.
Port is enabled by software, and loopback is on.
SPA power off.
SPA is ready and operational.
SPA power is on and good, and the SPA is being configured.
Cisco 7600 Series Router SIP, SSC, and SPA Hardware Installation Guide
3-33