2-Port And 4-Port Oc-48/Stm-16 Pos Spa Overview - Cisco XR 12000 Series Hardware Installation Manual

2-Port and 4-Port OC-48/STM-16 POS SPA Overview

Figure 2-42
1
The RPR mate cable is necessary only when the SPA is to be used in RPR mode. It is not needed in POS
Note
mode. Support for the RPR feature is dependent on the platform software release feature content. Verify
support for the RPR feature support by reviewing the relevant SPA datasheets or by contacting your
Cisco representative.

2-Port and 4-Port OC-48/STM-16 POS SPA Overview

The following sections describe the 2-Port and 4-Port OC-48/STM-16 POS SPA:
•
•
•
Cisco XR 12000 Series Router SIP and SPA Hardware Installation Guide
2-60
SPA Mate Cables
Long length RPR mate cable for single port
RPR SPAs (CBL-RPR-OC48-L)
2-Port and 4-Port OC-48/STM-16 POS SPA LEDs, page 2-61
2-Port and 4-Port OC-48/STM-16 POS SPA Interface Specifications, page 2-62
2-Port and 4-Port OC-48/STM-16 POS SPA Cables, Optical Transceiver Modules, and Connectors,
page 2-62
Chapter 2 Overview: Cisco XR 12000 Series Router Shared Port Adapters
1
2
2
Short length RPR mate cable for single port
RPR SPAs (CAB-RPR-OC48-S)
OL-17438-04