Adjusting The Beam Light 26 1 2 3 - Malaguti SPIDER MAX RS 500 Service Manual

ADJUSTING THE BEAM LIGHT
• The adjusting knobs (A) of the two headlamp beam light are located inside the central shield,
as indicated in the picture. To adjust the beam light it is not necessary to remove the central
shield.
A
F. 28
F. 27
To check/adjust the beam, proceed as follows:
• Put the vehicle in running conditions at 10 metres from a wall.
• Turn on the low beam headlights and keep the vehicle balanced without
a stand (lean it against a wall for instance).
• Turn the adjustment knobs of the two projectors (A) one at a time,
bearing in mind that turning clockwise lowers the beam, and anti-
clockwise raises it.
Adjust the beam so that its bottom line projected on the wall is at
about 78 cm from the floor.
26 02/08