Malaguti SPIDER MAX RS 500 Service Manual page 74

• Detach the (upper)
mount shaft (E).
• Remove the engine
mount and the spacers.
While
reassembling,
take care not to
interfere and
exchange the
spacers, which
will have to be
lubricated with
bearing grease.
F. 191
ENGINE MOUNT
• Place the mount (A) inside the frame.
• Fit the shaft (E).
• Fit the threaded bushing (C) including the lock nut (D) to the frame, taking care to
observe the prescribed torque.
• Fit the lock nut (D), tightening it completely to the frame.
• Fit the self-locking nut (B), tightening it to the prescribed torque.
C
10 ± 15%
B
35 ± 15%
If the bushing (C) was tightened too much, it may cause annoying
vibrations to the vehicle and irreparable damages to the bearing (U).
ANTI-VIBRATION
CONNECTING RODS
E
• After removing the
• Remove the screw (V) and
the washer (G).
• Remove the anti-vibration
connecting rods (H).
V
73 02/08
V
engine and its
mount, release the
nut (F - F. 193).
F. 192
65 ± 15%
E
F. 193
X
D
C
Y
B
A
U
X
V
G
H
Y
F