Yealink T46G Skype For Business Edition User Manual page 218

User Guide for the T46G Skype for Business phone
Switch between the Handset, Headset (if present) or Hands-Free Speakerphone to check

whether the dial tone is present for one of the audio modes.
If the dial tone exists on another audio mode, connect a different handset or headset to
isolate the problem.
Why doesn't the phone ring?
Check the ringer volume on the phone. To adjust the ringer volume setting, press the Volume
key when the phone is on-hook and idle. For more information, refer to
Why can't I receive calls?
Check that whether your status is DND mode, if it is, you should reset status. Refer to

Changing Presence Status
Check that whether call forward is disabled on the phone. Refer to

116.
Why doesn't my handset work?
Check that the headset cord is fully connected to the headset jack on the phone. Refer to

Phone Installation
Check that whether the headset volume is adjusted to an appropriate level. Refer to

Volume on page 50.
Why does the phone play a tone when there is a call on hold? How to disable it?
When there is a call on hold, the phone will play a hold tone every 30 seconds. Play hold tone is
enabled by default. Play hold tone and the interval of playing a hold tone are configurable via
web user interface only.
To configure play hold tone and play hold tone delay via web user interface:
Click on Features->General Information.
1.
Select Enabled or Disabled from the pull-down list of Play Hold Tone.
2.
206
on page 25.
on page 14.
Volume on page 50.
Call Forward on page