Configuring The Source Drobo Device - Drobo 5N2 User Manual

1.9.2.11

Configuring the Source Drobo Device

Configuring a Drobo device as the source for data replication enables it to control the
synchronization process to a destination, or target, Drobo device.
These steps assume you have already set up two Drobo devices on your network for data replication.
See Setting Up Your Drobo device to Use DroboDR
Note:
You need to be logged in as the administrator on the appropriate Drobo device to perform
this action.
1. In Drobo Dashboard, on the All Drobos page, select the Drobo device that you would like to
designate as the source.
2. Click the DroboDR option on the Navigation menu. The DroboDR page opens.
3. Click the Setup DroboDR button. The Setup DroboDR dialog page opens.
4. At the top, click the Sync as Source option. All the controls in the dialog box become enabled.
Drobo5N2 User Guide
for details.
203