Inserting An Msata Ssd - Drobo 5N2 User Manual

1.10

Inserting an mSATA SSD

You can insert an mSATA SSD into your Drobo 5N2. Doing so provides accelerated performance
when reading data from your Drobo 5N2. For more information on drive requirements, see Selecting
Drives.
It is best to insert the mSATA SSD before inserting drives into the Drobo 5N2's drive bays.
Important Notes:
The mSATA SSD is not part of your Drobo device's disk pack, so you can add or remove it
at any time.
Your Drobo device must be powered off and unplugged before adding or removing an
mSATA SSD.
It is important to ground yourself before installing the mSATA SSD in order to discharge
static electricity. To do so, touch a grounded metal object just before installation.
Warning:
If there is any pre-existing data on the mSATA SSD it will be erased. If you wish to keep the
data, copy it to another drive or medium before using with your Drobo device.
To insert an mSATA SSD into your Drobo 5N2:
1. Gently turn the Drobo 5N2 on to its side to access the bottom of the Drobo 5N2, and open the
Drobo Accelerator Bay door.
2. Slide the mSATA SSD into the slot as depicted in the image below.
3. Push the mSATA SSD down to lock in place by using the two pins on the mSATA latch.
Drobo5N2 User Guide 210