DG Flugzeugbau DG-1000T Maintenance Manual page 146

Enclosure 4 for Maintenance Manual DG-1000T
Section 3 Maintenance
3.3 Greasing and oiling
Subsection amended
•
Electrically operated landing gear: Clean and grease the slotted hole at
the attachment of the spindle drive to the bell crank 10FW106 (see
diagram 21).
Caution: The linear guide on which the spindle drive is moving during
emergency extension of the landing gear is made from plastic and should not be
greased .
If these parts have been greased inadvertently you have to disassemble the parts
and to clean them completely with Acetone.
Section 4 Detailed instructions for assembly and servicing work
4.5 Removal and installation of the undercarriage (main wheel)
New Subsection
4.5.3 Electrically operated main landing gear
see diagrams 20 and 21
A-D Removal of the main wheel of the brake assembly from the main wheel of
the lower landing gear fork 10FW11/1 and removal of the spring legs 10FW2
see section 4.5.1 A-D
E. Removal of the drag struts 10FW102 (left)
1 Remove the main wheel see
2 Disassemble the gas strut from the left side of the landing gear box see
section 4.5.0
3 Remove the 2 bolts M8 LN9037 which connect the struts to fork
10FW10/1. Mark the bolts. Don't interchange the bolts during
reassembly!
4 Remove the 2 bolts M8×40 LN9037 which connect the struts to the rear
fork 10FW91.
5 Remove the struts.
F. Removal of the front fork 10Fw10/1
see section 4.5.1 F
G. Removal of the shaft10FW109 (with the latches for locking the LG in
retracted position)
1 Remove the baggage compartment floor and the rear cover of the baggage
compartment.
2 Disconnect the wiring from the limit switch (mounted to the left latch of
the shaft).
3 Remove the push rod 10FW121 between bell crank 10FW130 and lever
10FW89.
Issued: October 2014
10FW102/2 (right)
A.
see section 4.5.1
TN1000/24 page of 8
4