DG Flugzeugbau DG-1000T Maintenance Manual page 137

Enclosure 2 for Maintenance Manual DG-1000T
A pipe clamp is mounted to the bulkhead, next to the spindle drive, holding the
cable form. Unscrew the screw in order to attach another clamp (180° inverted
to the original clamp), holding the aerial cable (see picture 4 ).
Feed the aerial cable underneath the control unit to the transponder aerial and
attach the BNC-Connector ( Bayonet nut connector). Attach to BNC- angular
connector and connect to aerial.
Issued: June 2005
picture 4
rear main bulkhead
aerial cable fixed with pipe
clamp
Cover the aerial wire in the
engine bay with aluminium tape
picture 5
aerial in engine bay
Antenna connector
page 4 of 6