DG Flugzeugbau DG-1000T Maintenance Manual page 100

Motorglider
Hide thumbs Also See for DG-1000T:
Table of Contents

Advertisement

Maintenance Manual DG-1000T
Instruments which are not part of the minimum equipment:
Transponders:
Transponders certified for aircraft use according to TSO or JTSO or ETSO
standards may be installed.
Installation of transponder and transponder antenna must be accomplished
according to enclosure 2 for this MM or technical note DG-G-02.
After installation, a functional test and inspection must be performed by a
licensed inspector.
ELT:
The ELT is or must be installed according to the ELT manufacturers
instructions.
The designated place is the baggage compartment on the floor.
Installation of ELT antenna must be accomplished according to drawing Z193
(attached to the MM).
After installation, a functional test and inspection must be performed by a
licensed inspector.
The ELT must be switched off during road transport.
Other instruments and equipment (eg. variometers, gliding computers or
flight data recorders):
Instruments and other equipment may be installed if they do not in themselves,
or by their effect upon the sailplane, constitute a hazard to safe operation.
Caution: If additional instruments or equipment are to be installed after
production of the glider, it must be assured that they will be installed in the
places provided by the design. If installed in other places it must be assured that
they are secured safely.
Electrical instruments and equipment must be connected via appropriately rated
fuses, the power consumption of each single part should not exceed 3A.
After installation raise a new weight and balance report.
Warning: If equipment is mounted on the canopies special care must be taken
that canopy jettison is not impaired. To accomplish this any wire must be
equipped with a plug in the vertical part. All plugs must be able to disconnect
with low force, max. 10 N (2 lbs.). The wires must be long enough for the
canopies to be opened completely before the wires are tight.
Equipment shall only be mounted at the fastening threads in the canopy frame
provided by the design.
Max. mass of the equipment per canopy: 1 kg (2 lbs.).
Issued: February 2011
TN1000/18
6.4

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dg-1000

Table of Contents