List Of Special Tools Etc - DG Flugzeugbau DG-1000T Maintenance Manual

7 List of special tools etc.

A Special tool with 6 mm thread (W38/2) for the securing of the tailplane and
for the locking pins of the rear wing suspension.
B Special tool W36 (or a suitable pin with 6mm diameter) for derigging of the
outboard wings and for the cover plate of the ballast box in the fin.
C Tool for airbrake adjustment: 5V17 and rod according to drawing 5V18.
D Open-end wrenches
1/4"
SW 7
SW 8
SW 9
SW 10
SW 12
E Allen key wrench
3 mm, 4 mm, 5 mm, 6 mm, 7 mm, 8 mm, 10 mm and 12 mm
F Circlip pliers A (outside) for the range 8-14 mm for the tail wheel axis
G Spring balance max. reading 50 N (11 lbs.) for determination of control
surface moments (see section 1.10)
H Spring balance max. reading 100 N (22 lbs.) for determination of airbrake
overcentre locking moments (see section 4.4.2
I Nicopress tool 64 – CGMP for cable connections
J For filling the wing ballast tanks: Hose with outside dia 25 mm (1 in.), 1 m
(3.2 ft.) long.
K For filling the fin ballast tank: Z27/2 Funnel with clear PVC hose inner
diameter 12 mm (.47 in.) 1.9 m (6 ft.) long and hose connector GS 12.
L Refuelling hose for fuselage fuel tank Z155/1
M Torque wrench range 0 - 50 Nm (0 - 370 ft lb) with socket wrenches 10, 13,
17, 19 mm and 21 mm (13/16 in.) for sparkplugs and Allen key inserts 3, 4,
5, 10 mm
N Wrench for spark plugs 21 mm (13/16 in.)
O Spring balance max. reading 200 N (44 lbs.) for measuring belt tension
P Crimp tool for clamps XO for 6mm bungee (bungee for retaining cable)
Issued: October 2014
Maintenance Manual DG-1000T
= 6,35 mm SW 13
SW 14
SW 17
11/16" = 18 mm
SW 19
SW 22
TN1000/24 7.1