Enclosure 2 for Maintenance Manual DG-1000T
3. Installation of the transponder
Mount the transponder to a suitable place on the instrument panel.
Connect the HF-Connector to the transponder. Power supply takes place through
wire nr. 13(+),included in the wiring harness. Protection is then ensured via the
installed circuit breaker (marked with XPDR). Connect earth-wire of the
transponder to the earth conductor at the left front end base of the instrument
panel console.
4. Inspection
The installation has to be examined by an avionics inspector class 1 with the
appropriate authorisation.
Issued: June 2005
page 5 of 6