Reading The Barometric Pressure; Reading The Barometric Pressure For The Last 12 Hours; Setting The Channel; Displaying The Outdoor Temperature - Auriol IAN 94604 Operation And Safety Notes

from your device and from the local weather
forecasting service, please take the advice of the
latter as authoritative.
Press the HISTORY / WEATHER button
for about 3 seconds. The weather symbol
flashes.
Set the current weather by pressing
the "+" / °C / °F button
"–" / MAX / MIN button
You can choose between the following
weather symbols:
Press the HISTORY / WEATHER button
confirm your settings.
Note: Ensure that you have set the current
weather correctly, otherwise the weather
forecast will not be correctly displayed.
The weather station starts with the weather
forecast approximately 6 hours after you
enter the current weather.
The weather station can display the barometric
pressure trend
25
displays:
= the barometric pressure will rise.
= the barometric pressure will remain
constant.
= the barometric pressure will fall.
Reading the barometric
pressure
Press the Relative / absolute barometric pres-
sure button to switch between the relative
30
and absolute barometric pressure display.
Note: The display shows "Abs" if you have
selected absolute pressure. The display shows
"Rel" if you have selected relative pressure.
Note: The absolute barometric pressure is
measured by the weather station.
10 GB/IE
94604_aur_Funk-Wetterstation_content_GB_FI_DK.indd 10
27
1
or the
28
.
29
= sunny
= light clouds
= cloudy
= cloudburst /
storm
= rainy
to
27
. You may see the following
Set the relative barometric pressure to the
barometric pressure relative to that at sea
level. Ask your local weather forecast service
for the barometric pressure at sea level.
Press and hold down the Relative / absolute
barometric pressure button
3 seconds.
Set the current barometric pressure by press-
ing the "+" / °C / °F button
"–" / MAX / MIN button
29
Press the Relative / absolute barometric
pressure button to confirm your settings.
30
Reading the barometric
pressure for the last 12 hours
Press the HISTORY / WEATHER button
to read the barometric pressure values for
the last 12 hours.
0HR = present barometric pressure
– 1HR = barometric pressure an hour earlier
– 2HR = barometric pressure two hours
earlier, etc.
Press and hold down the "+" / °C / °F button
for about 3 seconds to switch between
28
displaying the barometric pressure units in
inHg or mb / hPa.

Setting the channel

To do this open the battery compartment on
the back of the outdoor sensor and take it off.
Set the channel by means of the Channel
selection switch .
39
Press the channel button
26
seconds until a signal is sounded. The wea-
ther station has now received one signal.
Press the TX button to transmit the measured
42
temperature to the weather station manually.
Then close the battery compartment
Displaying the outdoor
temperature
Press the Channel button
outdoor temperature of each outdoor sensor.
– Press the Channel button
channel 1.
– Press the Channel button
channel 2.
– Press the Channel button
channel 3.
– Press the Channel button
all the channels one after the other in a loop.
Only the outdoor sensors which can be
addressed are displayed.
Press and hold down the Channel button
to remove unused channels. If a further out-
door sensor and channel are added later,
the weather station will receive the signal
automatically. Alternatively, you can also
transmit the initial signal from the outdoor
sensor manually by pressing the TX button
for about
30
or the
28
.
27
for approx. 3
.
40
to display the
26
1 x to display
26
2 x to display
26
3 x to display
26
4 x to display
26
26
.
42
28.08.13 13:16