Factory Default Settings; Settings Which Can Be Changed Via The Menu - Dräger Polytron 8100 Instructions For Use Manual

Factory default settings

7 Factory default settings
7.1

Settings which can be changed via the menu

Menu
Relay active on alarm / No alarm
A1 Alarm
A2 Alarm
A1 alarm: direction
(falling for DrägerSensor O2)
A2 alarm: direction
A1 latch mode
A2 latch mode
A1 acknowledgement mode
A2 acknowledgement mode
Normal operation A1 relay
Normal operation A2 relay
Hysteresis for A1 alarm at direction rising 0
Hysteresis for A2 alarm at direction rising 0
Calibration password
Settings password
LCD setting
SIL status
Language
Fault current
Warning
Warning current
Warning cycle time T1
Warning cycle time T2
Maintenance
Maintenance current
Analog offset
HART address
Auto-calibration
Calibration interval
Function key
34
Factory Default Setting
Active on alarm
Depending on the sensor
Depending on the sensor
Rising
Rising
Non-latching
Latching
Acknowledgeable
Not acknowledgeable
Energized
Energized
_ _ _1
_ _ _2
On
Off
EN
1.2 mA
Off
3.0 mA
10 sec
1 sec
static
3.4 mA
0 mA
0
Off
Depending on sensor
Faults
Range
On / Off
Falling / Rising
Latching / Non-Latching
Acknowledgeable / Not acknowledgeable
/ Pre-acknowledgeable
Energized / Not energized
0 to A1
0 to A2
On / Off
On / Off
DE / EN / FR / ES / RU / ZH
0 to 3.5 mA
On / Off
0 to 3.5 mA
5 to 60 sec.
1 to 59 sec.
Static / Dynamic
0 to 3.5 mA
- 0.2 to 1.5 mA
0 to 15
On / Off
0 to 720
Graph, fault, warning, vitality, bump test
Dräger Polytron 8100