Cleaning The Pre-Filter (Fig.v); Replacing The Filter; Understanding The Healthy Air Protect Lock; Replacing The Filters (Fig.y) - Philips AC2887 User Manual

Cleaning the pre-filter
(fig.v)
Filter alert light status
F0 displays on the
screen
1
Switch off the air purifier and unplug from
the wall outlet.
2
Pull the bottom part of the front panel to
remove it from the appliance (fig.d).
3
Press the two clips down and pull the pre-
filter towards you (fig.e).
4
Wash the pre-filter under a running tap. If
the pre-filter is very dirty, use a soft brush
to brush away the dust (fig.w).
5
Air dry the pre-filter.
Note
• To optimize the lifetime of the pre-filter, make
sure it dries completely after cleaning.
• Wash your hands after handling the filter.
6
Put the pre-filter back into the appliance
(fig.g).
Note
• Make sure that the side with the two clips is
pointing towards you, and that all hooks of the
pre-filter are properly attached to the purifier.
7
To reattach the front panel, mount the
panel onto the top of the appliance first
(1). Then, gently push the panel against the
body of the appliance (2) (fig.h).
8
Touch and hold the reset button
3 seconds to reset the pre-filter cleaning
time (fig.x).
Follow this
Clean the pre-filter
for
6 Replacing the filter
Understanding the healthy air
protect lock
This appliance is equipped with the healthy
air protect lock to make sure that the air
purification filter is in optimal condition when
the appliance is operating. When the filters are
almost expired, the filter code displays on the
screen to indicate that you need to replace the
filters.
If the filters are not replaced in 14 days, the
appliance will stop operating and get locked.
Replacing the filters (fig.y)
Note
• The air purification filters are not washable nor
vacuum cleanable.
• Switch off the appliance before replacing the
filters.
Filter alert light status
A3 displays on the
screen
C7 displays on the
screen
A3 and C7 display on
the screen alternately
Follow this
Replace the
NanoProtect filter
HEPA Series 3
(FY2422)
Replace the
NanoProtect filter
AC (FY2420)
Replace both filters
EN 9