FOR-A FA-9500 Operation Manual page 213

 Converter1 Audio Group
Parameter Default
Group1 Enable
Group 2 Enable
Group 3 Enable
*1
Group 4 Enable
*1 GROUP4 embedded audio cannot be inserted into SD-SDI output signals regardless of the
GROUP4 setting.
*2 The setting is ineffective if the input and output formats are the same, and H ANC is set to In
Data under Converter1 Ancillary Setting.
 Converter2 Audio Group
Parameter Default
Group1 Enable
Group 2 Enable
Group 3 Enable
*1
Group 4 Enable
*1 GROUP4 embedded audio cannot be inserted into SD-SDI output signals regardless of the
GROUP4 setting.
*2 The setting is ineffective if the input and output formats are the same, and H ANC is set to In
Data under Converter2 Ancillary Setting.
 SD Line Mask
Parameter Default
Line6-23 Pass
 PAL-M Mode Set
Parameter Default
PAL-M
Disable
Mode Set
*1 This setting is effective on composite and Y/C outputs. NTSC and PAL signals can be input,
however, NTSC signal cannot be output. If this mode is enabled, GENLOCK IN recognizes
PAL-M signals as 525/60, however, NTSC BB signals become ineffective. (PAL BB signals
and tri-level sync signals can be used.)
Setting range
Disable: Does not insert GROUP 1-embedded
Disable
*2
audio.
Enable
Enable： Inserts GROUP 1-embedded audio.
Disable: Does not insert GROUP 2-embedded
Disable
*2
audio.
Enable
Enable： Inserts GROUP 2-embedded audio.
Disable: Does not insert GROUP 3-embedded
Disable
*2
audio.
Enable
Enable： Inserts GROUP 3-embedded audio.
Disable: Does not insert GROUP 4-embedded
Disable
*2
audio.
Enable
Enable： Inserts GROUP 4-embedded audio.
Setting range
Disable Disable: Does not insert GROUP 1-embedded audio.
*2
Enable Enable： Inserts GROUP 1-embedded audio.
Disable Disable: Does not insert GROUP 2-embedded audio.
*2
Enable Enable： Inserts GROUP 2-embedded audio.
Disable Disable: Does not insert GROUP 3-embedded audio.
*2
Enable Enable： Inserts GROUP 3-embedded audio.
Disable Disable: Does not insert GROUP 4-embedded audio.
*2
Enable Enable： Inserts GROUP 4-embedded audio.
Setting range Description
Pass: Outputs the line to a composite, Y/C or SD-SDI
Pass output signal without processing.
Blank Blank: Masks the selected composite, Y/C or SD-SDI
output signal line.
Setting range Description
Disable Disable: Allows NTSC signals to be output.
Enable Enable: Allows PAL-M signals to be output.
197
Description
Description
*1