Carrier-To-Noise, More Information - HP 8591C User Manual

4. If you want to store the results to a RAM card, insert a formatted RAM
card into the analyzer's card-insertion slot, press (SAVE) display-Xard ,
then press [m] [NIODEI) to return to channel measurement mode. Refer
to Chapter 3 for the procedure on formatting a RAM card.
5. If you want to print the results, press (ml.
6. Press MAIN MENU or More GO TO CSOKTB to exit the test.
a. If GO TO CSO/CT3 is pressed, the CSOKTB test is entered without
having to remeasure the carrier level.
CHANNEL TURNED ON? will be displayed. Be sure the channel
modulation is turned back on, then press MAIN MENU again.
Figure 2-13. Pressing RE-ENTER TEST restarts the test from the
beginning. Pressing TTL PWR Q INPUT calculates the total input power
making input level adjustments more convenient. Pressing MAIN MENU
exits the test.
JAN 25, 1995
CHANNEL
REF -4.3 dBmV
Uncorrected
Correct
LOG detect Noise
IF Noise Equlv. Pwr BW
Analyzer
Total
START 221.752
Figure 2-13. Carrier-to-Noise, More Information
CALCULATION
marker on
BW
measurement
Noise Correction (-2.91)
Power Input
STOP
Channel Measurements
Making Channel Measurements
-19.47
-16.97
-17.49
-20.41
RE-ENTER
C/N TEST
INPUT
227.752 MHz
T
YSWP 6.98