HP 8591C User Manual page 38

Steps 3 and 4 apply to an analyzer with an R-232 interface only. Refer to the HP 8590 E-Series Spectrum AnaQzer Programmer's
Guide, "Appendix C,' for more information about using the K-232 interface.
3 Connect the analyzer to the printer, using an HP 13242G. RS-232 cable. Turn the printer on.
PLOTTERS ARE NOT SUPPORTED BY THE HP 85721A PERSONALITY.
4 Press , MORE
1 of
the baud rate of the analyzer. [The baud rate of the analyzer must match the baud rate of the printerA
N O T E
If you are using an HP 22250 ITS-232 Thinkjet printer, refer to "Printing and Plotting" chapter of the
User's Guide, for your spectrum analyzer, for information about Thinkjet switch settings.
3
, enter a baud rata with the data keys, than press [ENTER) to set
BAUD RATE,
Getting Started
Setup for Cable TV Measurements
l-11