Menu Mode; Parameter Groups; Changing Data; Changing A Text Value - Danfoss FCM 300 Series Design Manual

Menu mode

The Menu mode is started by pressing the [MENU]
key, which produces the following read-out on the
display:
FREQUENCY
50.0 HZ
0..
KEYB. & DISPLAY
Line 3 on the display shows the parameter group
number and name.

Parameter groups

In the Menu mode the parameters are divided into
groups. Selection of parameter group is effected by
means of the [<>] keys.
The following parameter groups are accessible:
Group no. Parameter group:
0 Operation & Display
1 Load & Motor
2 References & Limits
3 Inputs & Outputs
4 Special functions
5 Serial communication
6 Technical functions
*For information on parameter group 800 and 900 for
PROFIBUS, please see the FCM Profibus manual
MG.03.EX.YY.
When the desired parameter group has been
selected, each parameter can be chosen by means of
the [+/-] keys:
FREQUENCY
50.0 HZ
001 LANGUAGE
ENGLISH
The 3rd line of the display shows the parameter
number and name, while the status/value of the
selected parameter is shown in line 4.
32
FCM 300 Series

Changing data

Regardless of whether a parameter has been
selected under the Quick menu or the Menu mode,
the procedure for changing data is the same.
Pressing the [CHANGE DATA] key gives access to
changing the selected parameter, following which the
underlining in line 4 will flash on the display.
The procedure for changing data depends on
whether the selected parameter represents a
numerical data value or a text value.

Changing a text value

If the selected parameter is a text value, the text value
is changed by means of the [+/-] keys.
FREQUENCY
50.0 HZ
001 LANGUAGE
ENGLISH
The bottom display line shows the text value that will
be entered (saved) when acknowledgement is given
[OK].
MG.03.B6.02 - VLT is a registered Danfoss trademark