Table 4- 2 Typical Liquid Application Problems; Figure 4-10 Liquid Application Problems Tab - Siemens SITRANS F Programming Manual

Menu Screens
4.6 Utilities Menu
Application Problems Tab
Select the [Application Problems] tab to display problems with the current proposed
flowmeter configuration. This tab will only appear if problems are found.
Figure 4-10 Liquid Application Problems Tab
Table 4- 2
Maximum pipe diameter exceeded. (Select larger sensor size.)
Maximum pipe diameter exceeded. (Select smaller sensor size.)
Pipe diameter too small for selected sensor.
Flow velocity exceeds limit of installation.
Accuracy limitation at minimum velocity.
Temperature above sensor limits.
Temperature below sensor limits.
Poor sensor match to pipe wall. [Consult factory]
Poor diameter to wall thickness ratio. [Consult factory]
Excessive wall thickness. [Consult factory]
Pipe diameter must be greater than "____". [Consult factory]. If "inch" units is selected: 0.25 inches. If
"mm" units is selected: 6.35 mm.
Operation in or near Reynolds transition.
42
Typical Liquid Application Problems
Warning Descriptions
Programming Manual, 10/2011, A5E02951525-03
Si-Ware Quick Start