Calling The Attendant - NEC Electra mark II Manual

MONITORING AN OUTSIDE CALL
CALLING THE ATTENDANT
.With terminal idle. depress CNF button. LED flashes
.1st line button LEDoff- nooff-hook ringing
LED on -off-hook ringing
.2nd line button LED off -voice announce provided
LED on -tone ringing provided
.3rd line button LED off -ringing tone #1
LED on -ringing tone #2
.After osslgnments are set. depress CNF button. LED goes off
PLACING AN OUTSIDE CALL
.Lift handset
.Dlallhe Trunk Access Code -
OR
.Lift handset
.Depress Idle outside lIne but1on
THEN
.Diallhe desired telephone number
OR
.Dial Station Speed DIal # (00-19)
OR
.Dial System Speed Dial # (20-99)
OR
.Depress * but1on for Last Number RedIal
ANSWERING AN OUTSIDE CALL
.ReceIve Incoming ringing cali
.Lift handset
.Depress flashing ANS button .
OR
.Lift handset
.Depress flashing lIne button.
ow,en rlnOng lIne preference Is 0S1igned. thls step b not ~
.Establish handset connection as oufllned above
.Depress SPKR button. LED lIghts
.Replace handset (adjust speaker volume If heeded)
.lift handset to resume conversation
.lift handset
.OlalO
.Lift handsel
.Dial desired statIon number
.Voice announce after hearing lone bursl or hear rtngback
.Dial 1 10 change valce announce 10 ringing call
.ReceIve ringing or voice announce call
.LIft handset
.Depress flashing ANS button or extensIon button .
OR
.ReceIve voice page call
.Ensure MIC button LED Is lIt
.Respond handsfree
'When ringing lIne preference b assigned. this step b not required