Siemens SIMATIC HMI KP400 Comfort Operating Instructions Manual page 101

Activating memory management
Note
Memory management
If you do not activate memory management, undefined states can occur during the runtime
of the project.
Requirement
The Control Panel is open.
Procedure
Proceed as follows:
1. Open the "OP Properties" dialog using the "OP" icon.
2. Change to the "Memory Monitoring" tab.
3. If you want to enable memory management, select "Shut down HMI Runtime...".
4. Confirm your entries with "OK".
Result
Memory management is activated. An open project is closed under these circumstances:
● Insufficient RAM
● RAM needs to be reorganized
An alarm is then triggered on the HMI device. Restart the project on the HMI device.
Comfort Panels
Operating Instructions, 07/2017, A5E36770603-AB
Commissioning the device
4.3 Parameter assignment for Comfort Panel
101