Siemens SIMATIC HMI KP400 Comfort Operating Instructions Manual page 97

Procedure
1. Open the "Transfer Settings" dialog using the "Transfer" icon.
①
②
③
④
2. Change to the "General" tab.
3. In the "Transfer" group, select whether you want to enable or disable "Transfer" mode.
Select one of the following options:
– Off – Transfer is not possible
– Manual – Manual transfer
– Automatic – Automatic transfer
Comfort Panels
Operating Instructions, 07/2017, A5E36770603-AB
Transfer group
Digital signatures group
Transfer channel group
Button for parameter assignment of the transfer channel properties
If you want to initiate a transfer, close the active project and press the "Transfer"
button in the Start Center.
A transfer can be remotely triggered from a configuration PC or a programming
device. The running project is closed immediately in this case and the transfer is
started.
WARNING
Unintended reactions during automatic transfer
When an automatic transfer starts and the running project is closed immediately, this
could cause unintentional reactions to be triggered in the plant. This can result in
personal injury or material damage.
Take the following measures to prevent undesired reactions in the plant:
• Select the "Off" or "Manual" setting for "Transfer" after the commissioning phase.
• Assign a password in the Control Panel to restrict access to the transfer settings
by unauthorized persons.
Commissioning the device
4.3 Parameter assignment for Comfort Panel
97