Configure Web Server - Siemens SIMATIC HMI KP400 Comfort Operating Instructions Manual

4.3.10.9

Configure Web Server

You can use this option to configure the HMI device as HTTP server. You can then view the
HTML pages of the server HMI device using a Web browser or access the tags of the server
HMI device using the "SIMATIC HMI HTTP Protocol". Read or write access to the tags is
possible, depending on the parameter assignment of the Web Server.
Requirement
● The Web Server is a component of the Sm@rtServer option. For HMI devices with an
image that is compatible with WinCC (TIA Portal) prior to V14, the following applies: The
HMI device has a Sm@rt Server license that was transferred to the HMI device via the
Automation License Manager. Starting with WinCC (TIA Portal) V14, the Sm@tServer
option for Comfort Panels is license-free.
● The HMI device has a project that was compiled with one of the following options in the
Runtime settings of the HMI device under "Runtime settings > Services":
– "HTML pages"
– "HTTP channel server"
– "Web Service SOAP"
● The Control Panel is open.
● Your system administrator has provided you with the necessary information for parameter
assignment of the Web Server.
Note
The "Web Server" tab is only available if the HMI device has a project that was compiled with
one of the three Runtime settings listed under "Requirements".
Additional tabs may appear in the "WinCC Internet Settings" dialog. This depends on the
options that have been enabled for operating the local network in the project.
Comfort Panels
Operating Instructions, 07/2017, A5E36770603-AB
Commissioning the device
4.3 Parameter assignment for Comfort Panel
131