Modifying The Pim Router Query Message Interval - Cisco Catalyst 3850 series Configuration Manual

Modifying the PIM Router Query Message Interval

DETAILED STEPS
Command or Action
Step 1
enable
Example:
Device> enable
Step 2 configure terminal
Example:
Device# configure terminal
Step 3
ip multicast rpf backoff minimum maximum [disable]
Example:
Device(config)# ip multicast rpf backoff 100 2500
Related Topics
RPF Failover, on page 341
Example Configuring PIM RPF Failover Intervals, on page 347
Modifying the PIM Router Query Message Interval
Perform this task to modify the PIM router query message interval.
SUMMARY STEPS
1. enable
2. configure terminal
3. interface type slot / subslot / port
4. ip pim query-interval period [msec]
DETAILED STEPS
Command or Action
Step 1 enable
Example:
Device> enable
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3.6E (Catalyst 3850 Switches)
344
IP Multicast Optimization: Multicast Subsecond Convergence
Purpose
Enables privileged EXEC mode.
• Enter your password if prompted.
Enters global configuration mode.
Configures the minimum and the maximum backoff
intervals.
Purpose
Enables privileged EXEC mode.
• Enter your password if prompted.
OL-32598-01