Configuring Wireless Multicast-Mcuc Mode (Cli) - Cisco Catalyst 3850 series Configuration Manual

Configuring Wireless Multicast
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Device> enable
Step 2
configure terminal
Example:
Device# configure terminal
Step 3
wireless multicast
Example:
Device(config)# wireless multicast
Device(config)# no wireless multicast
Step 4 ap capwap multicast ipaddr
Example:
Device(config)# ap capwap multicast 231.1.1.1
Device(config)# no ap capwap multicast
231.1.1.1
Step 5 end
Example:
Device(config)# end
Related Topics
Information About Wireless Multicast, on page 242

Configuring Wireless Multicast-MCUC Mode (CLI)

SUMMARY STEPS
1. enable
2. configure terminal
3. wireless multicast
4. no ap capwap multicast ipaddr
5. end
OL-32598-01
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3.6E (Catalyst 3850 Switches)
Configuring Wireless Multicast-MCUC Mode (CLI)
Purpose
Enables privileged EXEC mode.
• Enter your password if prompted.
Enters global command mode.
Enables the multicast traffic for wireless clients. The default
value is disable. Add no in the command to disable the
multicast traffic for wireless clients.
Enables the forwarding mode in multicast. Add no in the
command to disable the multicast mode.
Exits the configuration mode. Alternatively, press Ctrl-Z to
exit the configuration mode.
247