Configuring PIM MIB Extension for IP Multicast
•
•
•
•
•
Finding Feature Information
Your software release may not support all the features documented in this module. For the latest caveats and
feature information, see Bug Search Tool and the release notes for your platform and software release. To
find information about the features documented in this module, and to see a list of the releases in which each
feature is supported, see the feature information table at the end of this module.
Use Cisco Feature Navigator to find information about platform support and Cisco software image support.
To access Cisco Feature Navigator, go to http://www.cisco.com/go/cfn. An account on Cisco.com is not
required.
Information About PIM MIB Extension for IP Multicast
PIM MIB Extensions for SNMP Traps for IP Multicast
Protocol Independent Multicast (PIM) is an IP multicast routing protocol used for routing multicast data
packets to multicast groups. RFC 2934 defines the PIM MIB for IPv4, which describes managed objects that
enable users to remotely monitor and configure PIM using Simple Network Management Protocol (SNMP).
PIM MIB extensions introduce the following new classes of PIM notifications:
• neighbor-change--This notification results from the following conditions:
OL-32598-01
Finding Feature Information, page 189
Information About PIM MIB Extension for IP Multicast, page 189
How to Configure PIM MIB Extension for IP Multicast, page 190
Configuration Examples for PIM MIB Extensions, page 192
Additional References, page 192
• A router's PIM interface is disabled or enabled (using the ip pim command in interface configuration
mode)
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3.6E (Catalyst 3850 Switches)
8
C H A P T E R
189