Controlling The Receipt Of Sa Messages From Msdp Peers Using Incoming Filter Lists - Cisco Catalyst 3850 series Configuration Manual

Configuring MSDP
Command or Action
Step 5
exit
Example:
Device(config)# exit
Controlling the Receipt of SA Messages from MSDP Peers Using Incoming
Filter Lists
Perform this optional task to control the receipt of incoming SA messages from MSDP peers.
For best practice information related to configuring MSDP SA message filters, see the
Note
Discovery Protocol SA Filter Recommendations
SUMMARY STEPS
1. enable
2. configure terminal
3. ip msdp sa-filter in {peer-address | peer-name} [list access-list] [route-map map-name] [rp-list access-list
| rp-route-map map-name]
4. Repeat Step 3 to configure incoming filter lists for additional MSDP peers.
5. exit
DETAILED STEPS
Command or Action
Step 1 enable
Example:
Device> enable
Step 2
configure terminal
Example:
Device# configure terminal
OL-32598-01

Controlling the Receipt of SA Messages from MSDP Peers Using Incoming Filter Lists

IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3.6E (Catalyst 3850 Switches)
Purpose
Exits global configuration mode and returns to
privileged EXEC mode.
tech note.
Purpose
Enables privileged EXEC mode.
• Enter your password if prompted.
Enters global configuration mode.
Multicast Source
223