Configuring The Igmp Leave Timer (Cli) - Cisco Catalyst 3850 series Configuration Manual

How to Configure IGMP Snooping
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Device> enable
Step 2
configure terminal
Example:
Device# configure terminal
Step 3 ip igmp snooping vlan vlan-id immediate-leave
Example:
Device(config)# ip igmp snooping vlan 21
immediate-leave
Step 4 end
Example:
Device(config)# end
Step 5
show ip igmp snooping vlan vlan-id
Example:
Device# show ip igmp snooping vlan 21
Step 6
end
Example:
Device(config)# end
Related Topics
Immediate Leave , on page 42

Configuring the IGMP Leave Timer (CLI)

You can configure the leave time globally or on a per-VLAN basis. Follow these steps to enable the IGMP
configurable-leave timer:
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3.6E (Catalyst 3850 Switches)
78
Purpose
Enables privileged EXEC mode. Enter your password if
prompted.
Enters the global configuration mode.
Enables IGMP Immediate Leave on the VLAN interface.
Note To disable IGMP Immediate Leave on a VLAN, use
the no ip igmp snooping vlan vlan-id
immediate-leave global configuration command.
Returns to privileged EXEC mode.
Verifies that Immediate Leave is enabled on the VLAN
interface.
Returns to privileged EXEC mode.
Configuring IGMP
OL-32598-01