Setting The Maximum Number Of Igmp Groups (Cli) - Cisco Catalyst 3850 series Configuration Manual

Setting the Maximum Number of IGMP Groups (CLI)

Command or Action
Step 2
configure terminal
Example:
Device# configure terminal
Step 3 interface interface-id
Example:
Device(config)# interface
gigabitethernet1/0/1
Step 4 ip igmp filter profile number
Example:
Device(config-if)# ip igmp filter 321
Step 5
end
Example:
Device(config-if)# end
Step 6 show running-config
Example:
Device# show running-config
Step 7
copy running-config startup-config
Example:
Device# copy running-config startup-config
Setting the Maximum Number of IGMP Groups (CLI)
Follow these steps to set the maximum number of IGMP groups that a Layer 2 interface can join:
Before You Begin
This restriction can be applied to Layer 2 ports only; you cannot set a maximum number of IGMP groups on
routed ports or SVIs. You also can use this command on a logical EtherChannel interface but cannot use it
on ports that belong to an EtherChannel port group.
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3.6E (Catalyst 3850 Switches)
62
Purpose
Enters the global configuration mode.
Specifies the physical interface, and enters interface
configuration mode. The interface must be a Layer 2 port that
does not belong to an EtherChannel port group.
Applies the specified IGMP profile to the interface. The range
is 1 to 4294967295.
To remove a profile from an interface, use the no ip
Note
igmp filter profile number interface configuration
command.
Returns to privileged EXEC mode.
Verifies your entries.
(Optional) Saves your entries in the configuration file.
Configuring IGMP
OL-32598-01