Changing The Igmp Version(Cli) - Cisco Catalyst 3850 series Configuration Manual

Configuring IGMP
Command or Action
Step 5
exit
Example:
Device(config-igmp-profile)# exit
Step 6 interface interface-id
Example:
Device(config)# interface
gigabitethernet 1/0/1
Step 7 ip igmp filter filter_number
Example:
Device(config-if)# ip igmp filter 10
Step 8 end
Example:
Device(config)# end
Step 9 show ip igmp interface [interface-id]
Example:
Device# show ip igmp interface
Step 10 copy running-config startup-config
Example:
Device# copy running-config startup-config

Changing the IGMP Version(CLI)

By default, the switch uses IGMP Version 2, which provides features such as the IGMP query timeout and
the maximum query response time.
All systems on the subnet must support the same version. The switch does not automatically detect Version
1 systems and switch to Version 1. You can mix Version 1 and Version 2 hosts on the subnet because Version
2 routers or switches always work correctly with IGMPv1 hosts.
OL-32598-01
Purpose
Returns to global configuration mode.
Specifies the interface to be configured, and enters interface
configuration mode.
Specifies the IGMP filter profile number.
For additional information about applying IGMP filter profiles,
see
Returns to privileged EXEC mode.
Verifies your entries.
(Optional) Saves your entries in the configuration file.
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3.6E (Catalyst 3850 Switches)
Changing the IGMP Version(CLI)
Applying IGMP Profiles (CLI), on page 61.
49