Cisco Catalyst 3850 series Configuration Manual page 72

Controlling Access to IP Multicast Group (CLI)
SUMMARY STEPS
1. enable
2. configure terminal
3. ip igmp profile
4. permit
5. exit
6. interface interface-id
7. ip igmp filter filter_number
8. end
9. show ip igmp interface [interface-id]
10. copy running-config startup-config
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Device> enable
Step 2
configure terminal
Example:
Device# configure terminal
Step 3 ip igmp profile
Example:
Device(config)# ip igmp profile 10
Device(config-igmp-profile)# ?
Step 4 permit
Example:
Device(config-igmp-profile)#
permit 229.9.9.0
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3.6E (Catalyst 3850 Switches)
48
Purpose
Enables privileged EXEC mode. Enter your password if prompted.
Enters the global configuration mode.
Enters an IGMP filter profile number from 1 to 4294967295.
For additional information about configuring IGMP filter profiles,
see Configuring IGMP Profiles (CLI), on page
Enters an IGMP profile configuration action. The following IGMP
profile configuration actions are supported:
• deny—Matching IP addresses are denied.
• exit—Exits from the IGMP profile configuration mode.
• no—Negates a command or set its defaults.
• permit—Matching addresses are permitted.
• range—Adds a range to the set.
Configuring IGMP
59.
OL-32598-01