Anritsu Spectrum Master User Manual page 117

SCPI SPA Commands
[:SENSe]:CHPower:BANDwidth|BWIDth:INTegration <numeric_value>
{HZ|KHZ|MHZ|GHZ}
[:SENSe]:CHPower:BANDwidth|BWIDth:INTegration?
Title: Channel Power Integration Bandwidth
Description: Sets the integration bandwidth for channel power measurement. Integration bandwidth
must be less than or equal to span
Parameter(s): <numeric_value> {HZ|KHZ|MHZ|GHZ}
Query Return : Numeric (Hz)
Default Value : 10350000 Hz
Default Unit : Hz
Range : 10 Hz to 200000000000 Hz
[:SENSe]:CHPower:STATe <0|1|ON|OFF>
[:SENSe]:CHPower:STATe?
Title: Channel Power State
Description: Sets the state of the channel power measurement, ON or OFF. When using
:CONFigure:CHPower the state is automatically set to ON
Parameter(s): <0|1|ON|OFF>
Query Return : 0 | 1
Default Value : OFF
[:SENSe]:DETector[:FUNCtion] <POSitive|NEGative>
[:SENSe]:DETector[:FUNCtion]?
Title: Detection Mode
Description: Sets the detection method for calculating each display point. Each display point
represents several measurements. The detection type determines how the display point is
derived from its associated measurements. POSitive Peak detection displays the
maximum value of the associated measurements. RMS detection displays the average
power of the associated measurements. NEGative Peak detection displays the minimum
value of the associated measurements.
Parameter(s): <POSitive|NEGative>
[:SENSe]:FREQuency:CENTer <numeric_value> {HZ|KHZ|MHZ|GHZ}
[:SENSe]:FREQuency:CENTer?
Title: Center Frequency
Description: Sets the center frequency. Note that changing the value of the center frequency will
change the value of the coupled parameters Start Frequency and Stop Frequency. It may
also change the value of the span.
Parameter(s): <numeric_value> {HZ|KHZ|MHZ|GHZ}
Query Return : Numeric (Hz)
Default Value : 35000000000 Hz
Default Unit : Hz
Range : 5 Hz to 69999999995 Hz
MS2760A UG PN: 10580-00427 Rev. C
8-12 SENSe Subsystem
8-37