Scale Details - GREAT PLANES PT-19 Instruction Manual

5. Make a 90-degree bend in the pushrod wire at the
marks – it will be easier to make the bends with the pushrods
out of the fuselage. Connect the pushrods to the servo arms
and snap on a 90-degree pushrod keeper. Then, cut off the
excess wire and install the servo arms back onto the servos.
6. Drill 1/16" [1.6mm] holes in the servo tray for the servos.
Then, mount the servos with the screws that came with them.
7. Mount the receiver and receiver battery (if used) with
straps made from more hook-and-loop material. Also mount
the receiver switch if used.

Scale Details

1. Use the lite-ply pilot mount doubler to mark and drill
holes in the cockpit fl oor in the location where you want
to install the pilot (we used a 3/32" [2.4mm] brass tube
sharpened on the end to cut the holes).
2. Use the doubler as a template to drill 1/16" [1.6mm]
holes in the base of the pilot.
3. Glue the doubler to the bottom of the cockpit fl oor. Then,
glue and screw the pilot to the cockpit fl oor with two #4 x
1/2" [13mm] sheet metal screws and #4 washers.
Refer to this image for gluing on the wind screens and
the crash protector.
20