Kit Contents; Preparation - GREAT PLANES PT-19 Instruction Manual

1
3
4
9
1. Cowl
2. Fuselage, Cockpit hatch
3. Wood Parts
4. Hardware Bag

PREPARATION

The cockpit hatch is removed by pulling forward on the latch
in the rear cockpit and lifting the rear of the cockpit up and
off the fuselage.

KIT CONTENTS

5
6
10
11
5. Right Wing
6. Left Wing
7. Horizontal Stabilizer
8. Vertical Stabilizer
2
12
13
9. Fuel Tank
10. Engine Mount
11. Nylon Hardware Bag
12. Fastener Hardware Bag
NOTE: The covering on your PT-19 requires less heat than
you may be used to if you're already familiar with iron-on
coverings – too much heat causes seams and edges to pull
and draw away from each other causing wavy, uneven edges
or exposed balsa. Follow the instructions below to tighten
the covering on your model.
1. Stack two or three paper towel squares on top of each
other and cut them into small squares. During various stages
of assembly these squares may be dampened with denatured
alcohol for epoxy clean up and other kinds of clean up.
4
7
14
13. Crash Protector,
Wind Screens
14. Landing Gear Wires
15. Pilot (not shown)
8