Install The Radio - GREAT PLANES PT-19 Instruction Manual

Here's a couple images of the fi nished cowl.

Install the Radio

1. Make the elevator and rudder pushrods as shown.
2. Install the pushrods into the guide tubes in the fuselage.
Using the holes in the rudder horn as a guide, drill 1/16"
[1.6mm] holes through the rudder. Mount the rudder horn
with two M2 x 10 sheet-metal screws. Remove the screws,
add a few drops of thin CA into the holes, allow to harden,
then mount the horn again.
3. Align the clevis holes in the elevator horn with the
hinge line, then drill the holes for the elevator horn. Mount
the elevator horn with two M2 x 12 machine-thread screws
and the back plate on the top of the elevator.
4. If necessary, enlarge the cutout in the servo tray to
fi t your servos. Then, fi t the servos into the tray, but don't
screw them down yet. Center the servo arms and control
surfaces, then mark the pushrods where they cross the
holes in the arms.
19