Setup; Installing The Steering Wheel; Checking The Fluid Levels And Tire Pressure - Toro WORKMAN GTX 07131 Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
Note: Determine the left and right sides of the machine
from the normal operating position.
1

Installing the Steering Wheel

Parts needed for this procedure:
1 Steering wheel
1 Cover
1 Washer (1/2 inch)
Procedure
1. If the cover is installed, remove it from the hub of the
steering wheel (Figure
2. Remove the locknut (1/2 inch) from the steering shaft
(Figure 3).
3. Slide the steering wheel and washer (1/2 inch) onto the
steering shaft (Figure
4. Secure the steering wheel to the shaft with the locknut
(1/2 inch) and tighten it to 27 to 34 N·m (20 to 25
ft-lb).
5. Install the cover on the steering wheel
Description
Steering wheel
Cover
Washer (1/2 inch)
No parts required
Operator's Manual
Parts Catalog
Safety training material
Registration Card
Predelivery Inspection Form
Certificate of Quality
Key
Charger cord
3).
3).
(Figure
Qty.
1
1
1
–
1
1
1
1
1
1
2
1
1. Cover
2. Locknut (1/2 inch)
3. Washer (1/2 inch)
3).
11
Use
Install the steering wheel (TC Models
only).
Check the fluid levels and tire pressure.
Read the Operator's Manual and view
the training material before operating
the machine.
Figure 3
4. Steering wheel
5. Steering shaft