Maintaining The Headlights - Toro WORKMAN GTX 07131 Operator's Manual

Maintaining the Headlights

Replacing the Bulbs
CAUTION
If you install a higher wattage bulb than the system
is designed for, you may damage the 12 V power
supply, or at a minimum, blow the fuse.
Always use the specified Toro LED bulb to prevent
this issue.
CAUTION
The bulbs become extremely hot when in operation.
Handling a hot bulb can cause severe burns and
personal injury.
Always all enough time to for the bulbs to cool
before replacing them. Use care whenever handling
the bulb.
Specification: See your Parts Catalog.
1. Disconnect the batteries; refer to
Batteries (page 35).
2. Open the hood; refer to
3. Disconnect the electrical connector for the harness
from the connector of the lamp assembly at the back
of the headlight housing
1. Headlight housing
2. Lamp assembly
4. Rotate the lamp assembly 1/4 turn counterclockwise
and moving it rearward, out of the headlight housing
(Figure 41).
5. Insert the new lamp assembly and headlight housing
and align the tabs in the lamp assembly with the slots
in the headlight housing
Disconnecting the
Accessing the Hood (page
(Figure 41).
Figure 41
3. Harness-electrical
connector
(Figure 41).
6. Secure lamp assembly by turning it 1/4 turn clockwise
(Figure 41).
7. Connect the electrical connector for the harness to the
connector of the new lamp assembly
8. Connect the batteries and close the hood; refer to
Connecting the Batteries (page
29).
37
(Figure 41).
36).