Toro WORKMAN GTX 07131 Operator's Manual page 38

Replacing the Headlight
1. Disconnect the batteries; refer to
Batteries (page 35).
2. Open the hood; refer to
3. Disconnect the electrical connector for the harness
from the connector of the lamp assembly
Figure 42
1. Speed clip
2. Opening in the bumper
3. Adjustment screw
4. Remove the speed clips that secure the headlight to the
headlight bracket (Figure
Note: Retain all parts for installation of the new
headlight.
5. Remove the headlight assembly by moving it forward
through the opening in the front bumper
6. Install the new headlight through the opening in the
bumper (Figure 42).
Note: Ensure the adjustment posts are lined up with
the holes in the mounting bracket behind the bumper.
7. Secure the headlight assembly with the speed clips that
you removed in step 4.
8. Connect the electrical connector for the harness to the
connector of the lamp assembly
9. Adjust the headlights to direct the beams to the desired
position, refer to Adjusting the Headlights (page
Disconnecting the
Accessing the Hood (page
(Figure 42).
4. Headlight
5. Lamp assembly
6. Harness-electrical
connector
42).
(Figure 42).
(Figure 42).
38).
Adjusting the Headlights
Use the following procedure to adjust the headlight beam
position whenever a headlight assembly is replaced or
removed.
29).
1. Turn the key switch to the O
the headlights.
2. At the back of the headlight assembly, rotate adjustment
screws (Figure
align the position of the cast beam.
3. Connect the battery and close the hood; refer to
Connecting the Batteries (page
38
position, and turn on
N
42) to pivot the headlight assembly and
36).