Figure 2.8 - Jumper J17 Settings For Analog Outputs; Figure 2.10 - Keypad/Display - Reliance electric GV3000/SE Hardware Reference, Installation, And Troubleshooting Manual

About the Drive
Step 1. Disconnect, lock out, and tag all incoming power to the drive.
Step 2. Wait five minutes for the DC bus capacitors to discharge.
Step 3. Disconnect any wiring from the faceplate of the drive.
Important: The cover is connected to the drive by the keypad/display cable. To
disconnect the cover, use the procedure below. Do not remove the
keypad/display.
Step 4. Remove the cover as follows:
a. Unscrew the attaching screw on the cover.
b. Lift the cover and carefully take it out of the heatsink as far as the flat
ribbon keypad cable will allow. This cable connects the display with the
Regulator board.
c. Use a screwdriver to slide the cable out of the connector on the Regulator
board to completely detach the cover.
Step 5. 24 to 43 A drives only: Remove the front panel by unscrewing the two
attaching screws.
Step 6. Verify that the DC bus voltage is zero by following the procedure in section
10.3.
Step 7. Locate jumper J17 on the Regulator board. Refer to figure 2.6.
Step 8. Locate pin 1 on jumper J17. Move the jumper to the desired setting as shown
in figure 2.8.
Voltage Output Option
V
In
C
In
Figure 2.8 – Jumper J17 Settings for Analog Outputs
Step 9. Reattach the cover. For 24 to 43 A drives, reattach the front panel before
reattaching the cover.
Important: Check that the display cable is reconnected to the Regulator board. You
will need to fold and route the cable under the heatsink before replacing
the cover.
Step 10. Reconnect wiring to the faceplate of the drive.
Step 11. Reapply input power.
Step 12. Verify that parameter P.012 is set correctly for either speed or current.
Pins 2-3
10 VDC
J17
(default)
Current Output Option
Pins 1-2
4-20 mA
V
In
C
In
J-17
2-9